One extra screw? Or is my screw loose?

[Weeeelz]

I was taking my ML apart just a few minutes ago to clean it for the season end and found a small screw lying in my lap and can't figure out where it goes.

I've got a Knight LK-93 stainless and, after removing the stock and the trigger mechanism, I discovered a small black screw(less than 1/2" long by 1/8"). I assume(bad choice of words) that it came from the trigger mechanism but I'll be dogged if I can find where it goes. Any of you pros have any ideas?

I'll finish cleaning and check back. Thanks.

[willettm]

Weeelz,

Check your trigger pull and see if it seems out of whack. I think all of the Knights have Timney triggers and there should be an adjustment screw but the one you found sounds a little big. I'll look at my Knight this evening and post again tomorrow if I see anything. It's one thing to have a screw loose, it's another to have it out (of who knows where). Good luck smile.gif

[Weeeelz]

Thanks archer. I swear I tried every single place that remotely looked like a screw would fit and nothing. Checked scope, sling, everything! The only thing I can think is that it fell out of my cleaning box, but I just ain't sure.

I dry fired it last night and everything seemed fine. I guess when it falls apart on the first shot next season, I'll figure out where it goes :D